00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 229
11 Fieldwork
11.9 Crop receptacle / straw receptacle
67087
83478
11.9.4 Adjusting the stationary knives
(standard straw chopper)
– Observe the general warnings at the beginning of
the "Fieldwork" chapter.
Adjusting the stationary knives
The length of cut can be varied by relocating the sta-
tionary knives (1) between position (A and B).
– Slacken off bolts (2) on both sides.
– Swivel stationary knives to any position, using
wrench.
– Bolt down bolts (2) on both sides.
Removing the stationary knives
– Unlock and pull out spring clip of rod (3).
– Pull out rod (3).
– Remove the stationary knives.
– Push in rod (3) and secure with spring clips.
Danger!
The cutting cylinders of the straw chopper can
run on even if the drive is switched off.
Death or serious injuries!
– Never touch any machine parts that con-
tinue running.
– Wait until all machine parts have com-
pletely stopped moving.
Danger!
Sharp-edged machine parts, sharp blades.
Death or serious injuries!
– Wear safety gloves.
70
19668
71
19669
2
1
2
3
A
B
Position of stationary
knives / knife carrier
Long chopped straw
A Chop shorter
B Chop longer
For operation in rape it is recommended setting the
knife carrier all the way down.
To Next Page
Loading...
