00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 97
5 Prior to initial operation
5.5 Feeder unit
67081
73259
5.5.4 Checking the cutterbar float springs
The cutterbar float springs (1) are pre-set ex works.
The cutterbar float springs (1) must be checked and
adjusted with the front attachment fitted.
– Fit the front attachment.
– Fit the crop dividers.
– Lower the cutterbar until the skids are about 100
mm above the ground.
The distance (Y) between the coupling pin cylinder
plate and the nuts should be 5 mm.
– Adjust the cutterbar float springs if required.
- To do this, adjust the cutterbar float springs
accordingly at the socket head bolts (2).
– Observe the general warnings at the beginning of
the Prior to initial operation chapter.
12
19598
13
19599
3
1
2
14
19600
2
Y
Danger!
Bolts may break when tilting the spring plates.
Death or serious injuries!
– Ensure that the tilted position of the
spring plate near the bolt pitch circle
diameter may be 1mm max.
– Grease bolt threads.
– Now turn the bolts in or out by
3 revolutions each (5 mm) max., one
after the other.
Adjusting the bolts (2):
Increasing the distance Turn bolts in
Reducing the distance Turn bolts out
To Next Page
Loading...
