Claas DOMINATOR 150 - 11.4 Front attachment

00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 197
11 Fieldwork
11.4 Front attachment
67087
11.4 Front attachment
82054
11.4.1 Adjusting the reel horizontally
(mechanically)
– Raise / lower reel until the reel poles (2) are in a
horizontal position.
– Observe the general warnings at the beginning of
the "Fieldwork" chapter.
– Relieve chain tension. To this end, pull chain down
at position (A) as far as possible and fit the spring
clip (1) into the front hole.
The spring-loaded cylinder is now blocked.
– Unlock and pull out pin (1) on both sides.
– Adjust reel by hand.
– Insert pin (1) on both sides and secure with spring
clip.
– Tension the chain. To this end, pull chain down at
position (A) as far as possible and fit the spring
clip (1) into the rear hole.
The spring-loaded cylinder now keeps the chain under
constant tension.
2
28386
1
A
2
3
28387
1
4
28386
1
A