Claas DOMINATOR 150 - Adjusting the Ground Speed Control Lever Actuating Resistance (DOMINATOR 150; 140)

00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 153
9 Driving and transportation
9.3 Chassis
67085
– Depress the clutch pedal (5) fully.
– Using the shift lever (4), adjust the machine to the
desired switch position.
– Release parking brake if required.
– After the gear has been engaged, release pedals
of foot brake and slowly release the clutch pedal.
Take the foot off of the clutch pedal (5), thus
avoiding unnecessary clutch drag.
The clutch engages and the machine starts off.
80261
9.3.5 Adjusting the ground speed control lever
actuating resistance (DOMINATOR 150 / 140)
– Observe the general warnings at the beginning of
the "Driving and transportation" chapter.
29
19458
30
19457
5
2
R
3
1
4
N
Gear Designation
N Neutral position
R Reverse gear
1 1st gear Fieldwork gear
2 2nd gear Fieldwork gear /
road gear
3 3rd gear Road gear
Note!
Shift lever locks during shifting.
Gear is difficult to engage.
– Release parking brake if required.
– Release foot brake pedals.
– Slowly release the clutch pedal.
– Depress the clutch pedal fully.
– Depress the foot brake pedals
downwards.
– Set shift lever to desired shift position.