Claas DOMINATOR 150 - Page 332

332 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
13 Maintenance
13.8 Drive belts / drive chains
67089
– Clean the grooves or the contact faces of pulleys
to be free from grease and rust.
– First put the belt (R7) on the spring-loaded varia-
ble speed pulley (2).
– Pull the belt into the variable-speed pulley (2) until
it is fully spread.
– Install belt (R7) on the upper variable-speed
pulley.
– Bolt down bracket (3) with bolts (4).
– Check / adjust the fan speed display.
– Let the variable-speed drive run up and down
through its entire range several times, then check
belt tension.
WARNING:
Use of unpermissible spare parts or
lubricants.
Machine damage or increased wear.
– Spare parts and lubricants must at least
comply with the technical standards
required by the manufacturer of the
implement!
– The use of genuine CLAAS spare parts
and lubricants is recommended.
Warning!
Pinch points during assembly work.
Bruises of limbs.
– Keep limbs out of the hazard area.
– Use suitable tools.
95
23404
96
23405
3
R7
4
4
1
2