Claas DOMINATOR 150 - Page 339

00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 339
13 Maintenance
13.8 Drive belts / drive chains
67089
– Clean the grooves or the contact faces of pulleys
to be free from grease and rust.
– Pull belt (R42) firmly between the pulley halves
and unscrew the bolts (1).
– Continue turning the variable speed drive about
2 revolutions.
– Adjust belt (R42).
– Install belt (R41).
– Fit the guards.
– Let the variable-speed drive run up and down
through its entire range several times, then check
belt tension.
– Adjust the threshing drum speed.
WARNING:
Use of unpermissible spare parts or
lubricants.
Machine damage or increased wear.
– Spare parts and lubricants must at least
comply with the technical standards
required by the manufacturer of the
implement!
– The use of genuine CLAAS spare parts
and lubricants is recommended.
Danger!
Pinch points due to pre-loaded components.
Consequences: Death or serious injuries
– Never move your hands between two pre-
loaded components.
– Use a special tool.
– Avoid the hazard area.
109
23400
R42
1
110
23399
R41