CodaOctopus F180R - Page 89

Software
Copyright © 2015 Coda Octopus Products Ltd
89
F180R MOTION Sensor User and Reference Guide
LED Colour
Field
Description
Red
Not Connected
Indicates that there is not a
connection on the selected
source.
Yellow
Connected (read only)
Indicates that there is a
connection to the F180R
System on the Ethernet port,
but that it is a read-only
connection.
Green
Connected
Indicates that there is a valid
connection to the F180R
System and that the system is
receiving data. Also, in
Ethernet mode the F180R
System can be controlled by
the application.
NOTE: It is important to note the difference between a read-only connection and a
control connection. Only if there is a control connection you can actively change the
F180R System setup. Read-only connections occur if the application is running in
playback mode; communicating with the F180R System using a COM port; or the PC
with MOTION Control installed has the incorrect IP address set. See Change IP Address
for information on how to change the IP Address.
Double clicking the Data Source LED will display the Connection Properties dialog.
The Status LED area displays the real time status of several parameters. And the Status field
displays the current system status. This can be one of six states:
LED Colour
Field
Description
Grey
Not Connected
There isn't a valid connection
to the Data Source.
Green
Operating Normally
There is a valid connection to
the selected Source and the
system appears to be
operating normally.
Yellow
Heading Initialisation
The F180R System is
initialising the heading.
Further details are displayed
in the Heading Initialisation
dialog.