Regulatory Notices B-11
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: Karen Williams Saved by: Karen Williams Saved date: 05/29/00 6:17 PM
Part Number: 168893-001 File name: APPB.doc
European Union Notice
Telecommunications Terminal Equipment with the CE marking
comply with Telecommunication Terminal Equipment and
Satellite Earth Station Equipment (TTE & SES) Directive
(98/13/EC), the EMC Directive (89/336/EEC), and the Low
Voltage Directive (73/23/EEC) issued by the European
Community.
Compliance with these directives implies conformity to the
following European Norms or Regulations (in brackets are the
equivalent international standards and regulations):
â–
EN55022 (CISPR 22)—Electromagnetic Interference
â–
EN50082-1 (IEC801-2, IEC801-3, IEC801-4)—
Electromagnetic Immunity
â–
EN60950 (IEC950)—Product Safety
â–
CTR21 (ETSI TBR21)—Attachment requirements for
connection to the analogue PSTNs of terminal equipment
The equipment has been approved in accordance with Council
Decision 98/482/EC for pan-European single terminal connection
to the Public Switched Telephone Network (PSTN). However,
due to differences between the individual PSTNs provided in
different countries, the approval does not, of itself, give an
unconditional assurance of successful operation on every PSTN
network termination point. In the event of problems, you should
contact your equipment supplier in the first instance.
The equipment is designed to work with all EU telephone
networks. However, the equipment may have interworking
difficulties for some connections on the EU public networks.
Dialling by loop disconnect pulses is not intended to be used on
the PSTN. This feature is only supported in consideration of PBX
or other equipment which requires pulse dialling. Network
compatibility is dependent on software switch settings which are
set automatically by the country selection. The user should
contact the equipment supplier in case of difficulty in network
settings.
If provided, use the Country Select Software supplied with the
product to configure your modem for the country in which you
are currently located. Selecting a country other than the one in
which you are currently located may cause your modem to be
configured in a way that violates the telecommunication
regulations/laws of that country. In addition, your modem may
not function properly if the correct country selection is not made.
To Next Page
Loading...
Need help?
General