2-14 Using the Keyboard
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Writer: Karen Williams Saved by: Integrity Group Saved date: 05/31/00 4:40 PM
Part Number: 168893-001 File name: CH02.doc
Enabling the Keypad at Startup
To set the computer to start up with the embedded numeric
keypad enabled
—
1. Turn on or restart the computer, then press
F10
when the
blinking cursor appears upper-right on the screen.
❏
To change the language, press
F2.
❏
For navigation instructions, press
F1.
2. Select Advanced
!
Device Options, then press
Enter.
3. Toggle on the Num Lock State at Boot field, then press
F10
.
4. To save your preferences, then close Computer Setup and
restart the computer, select File
!
Save Changes and Exit,
then press
Enter.
5. When prompted to confirm your action, press
F10.
To disable the embedded numeric keypad at startup
—
Repeat the above procedure, toggling off the Num Lock State at
Boot field.
NOTE:
The embedded numeric keypad can be enabled or disabled
with
Fn+Num Lk
in either startup state.
To Next Page
Loading...
Need help?
General