Compaq PORTABLE 386

1704 - 06 Fatal error while reading.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
1704 - 40 Cylinder 0 error. The following steps apply to error
codes 1700 - xx through 1717 - 73:
1704 - 55 Cylinder 1 error.
1. Check the system board jumper
1704 - 65 Exceeded maximum bad sector settings and retest
per track. (see Chapter 9, "Jumper and
Switch Settings").
1704 - 70 Failed translate mode. 2. Replace the fixed disk drive
signal and power cables and
1704 - 71 Failed nontranslated mode. retest.
3. Replace the fixed disk drive
1704 - 72 Exceeded maximum bad track and retest.
limit. 4. Replace the system board and
retest.
1704 - 73 Previously exceeded maximum
bad track limit.
1705 - xx Fixed Disk Drive Controller
Test.
1705 - 05 Failed to reset controller.
1705 - 44 Failed fixed disk drive
controller diagnostics.
1705 - 56 Failed controller RAM
diagnostics.
1705 - 57 Failed controller to drive
diagnostics.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
1706 - xx Fixed Disk Drive Ready Test The following steps apply to error
codes 1700 - xx through 1717 - 73:
1706 - 41 Drive not ready.
1. Check the system board jumper
1707 - xx Fixed Disk Drive Recalibrate settings and retest
Test (see Chapter 9, "Jumper and
Switch Settings").
1707 - 42 Failed to recalibrate fixed 2. Replace the fixed disk drive
disk drive. signal and power cables and
retest.
1708 - xx Fixed Disk Drive Format Bad 3. Replace the fixed disk drive
Track Test and retest.
4. Replace the system board and
1708 - 02 Exceeded maximum hard error retest.
limit.
1708 - 05 Failed to reset controller.