Compaq PORTABLE 386

1708 - 09 Format track bad failed.
1708 - 42 Recalibrate drive failed.
1708 - 43 Failed to format a cylinder
bad.
1708 - 58 Failed to write sector
buffer.
1708 - 59 Failed to read sector
buffer.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
1709 - xx Fixed Disk Drive Reset The following steps apply to error
Controller Test codes 1700 - xx through 1717 - 73:
1709 - 05 Failed to reset controller. 1. Check the system board jumper
settings and retest
1710 - xx Fixed Disk Drive Park Head (see Chapter 9, "Jumper and
Test Switch Settings").
2. Replace the fixed disk drive
1710 - 45 Failed to get fixed disk signal and power cables and
drive parameters from ROM. retest.
3. Replace the fixed disk drive
1710 - 47 Failed to park heads. and retest.
4. Replace the system board and
1714 - xx Fixed Disk Drive File retest.
Write Test
1714 - 01 Exceeded maximum soft error
limit.
1714 - 02 Exceeded maximum hard error
limit.
1714 - 03 Previously exceeded maximum
soft error limit.
1714 - 04 Previously exceeded maximum
hard error limit.
1714 - 05 Failed to reset controller.
1714 - 06 Fatal error while reading.
------------------------------------------------------------------------------
Error
Code Error Description Recommended Action
------------------------------------------------------------------------------
1714 - 07 Fatal error while writing. The following steps apply to error
codes 1700 - xx through 1717 - 73:
1714 - 08 Failed compare of write/
read buffers. 1. Check the system board jumper
settings and retest