Compaq ProLiant 5500 - Page 128

7-21
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Table 7-7
SCSI Cable Usage Matrix for Duplex Mode
(Duplex enabler board installed on drive cage backplane)
Controller Hot-Plug SCSI Hard
Drives in Internal
Drive Cage
2/4 DAT Drive
4/8 DAT Drive
Internal TurboDAT
Autoloader
8X SCSI CD-ROM
4/16 TurboDAT
15/30 DLT Drive
35/70 DLT Drive
Integrated
Controller
Port 1
■
Connect 19-inch
point-to-point
non-terminated
SCSI cable
(199606-007)
from SCSI Port 1
to SCSI Input 0
of duplex board.
■
Connect 22-inch 3-
device terminated SCSI
(199616-010) from SCSI
PORT 1 to the removable
media bay devices.
■
Use 50 to 68 pin adapter
(199618-001) if needed.
■
See Note 2
■
Connect 22-inch
3-device
terminated SCSI
cable (199606-
010) from SCSI
PORT 1 to the
removable
media bay
devices.
Continued