Compaq ProLiant 5500 - Page 129

7-22
Cabling for Wide-Ultra SCSI-3
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SCSI Cable Usage Matrix for Duplex Mode
Continued
Controller Hot-Plug SCSI Hard
Drives in Internal
Drive Cage
2/4 DAT Drive
4/8 DAT Drive
Internal TurboDAT
Autoloader
8X SCSI CD-ROM
4/16 TurboDAT
15/30 DLT Drive
35/70 DLT Drive
Integrated
Controller Port 2
See Note 5
.
■
Connect 19-inch
point-to-point
non-terminated
SCSI cable
(199606-007)
from SCSI Port 2
to SCSI Input 1 of
duplex board.
■
Connect 22-inch
3-device
terminated SCSI
(199616-010)
from duplex
enabler board to
the removable
media bay
devices.
■
Use 50-to-68 pin
adapter (199618-
001) if needed.
■
See Note 2.
■
Connect 22-inch
3-device
terminated SCSI
(199616-010)
from duplex
enabler board to
the removable
media bay
devices.
■
See Note 2.
continued