Compaq ProLiant 5500 - Page 132

7-25
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SCSI Cable Usage Matrix for Duplex Mode
Continued
Controller Hot-Plug SCSI Hard
Drives in Internal Drive
Cage
2/4 DAT Drive
4/8 DAT Drive
Internal TurboDAT
Autoloader
8X SCSI CD-ROM
4/16 TurboDAT
15/30 DLT Drive
35/70 DLT Drive
Smart-2 Array
Controller, /P,
/DH With
Loopback SCSI
Option
■
Use cable option
kit 306585-B21.
This kit includes
the loop back SCSI
cable kit and a
SCSI slot bracket.
■
Connect 19-inch
point-to-point non-
terminated SCSI
cable (199606-
007) from the
internal SCSI
connector of the
optional controller
board to SCSI Input
0 of the duplex
board.
■
Connect 8.75"
external loopback
SCSI cable from
external SCSI
connector of
optional controller
board to a SCSI
slot bracket. Install
this bracket in an
unused slot.
■
Connect 20-inch
cable shipped with
the optional
controller board
from SCSI slot
bracket to SCSI
Input 1 of duplex
board.
Tape Drives and CD-
ROMs are
not supported
using a SMART-2 Array
Controller
Tape Drives and CD-
ROMs are
not
supported
using a
SMART-2 Array
Controller
Continued