7-26
Cabling for Wide-Ultra SCSI-3
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: H-CH07.DOC Last Saved On: 2/8/99 11:06 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
SCSI Cable Usage Matrix for Duplex Mode
Continued
Note 1:
A third SCSI controller card is needed to connect to hard drive backplane SCSI
inputs 0 or 1 to support duplex mode operation for this configuration.
Note 2:
SCSI PORT 2 output will not operate at ultra SCSI speed if non-ultra drives are used
in the removable media bay.
Note 3:
If additional external 50- to 68-pin adapters are needed, order option kit 212055-
001.
Note 4:
The loopback SCSI option is not supported by the SMART-2/SL controller.
Note 5:
The SCSI Port 2 Controller is connected to the SCSI Port 2 connector and external
SCSI connector. It is recommended that you use SCSI Port 2 controller for either internal or
external drives, not both.
To Next Page
Loading...
