Compaq ProLiant 5500 - Page 64

4-6
Installing Hardware Components
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: E-CH04.DOC Last Saved On: 2/12/99 12:18 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
1. To add a processor, identify the processor locations as shown in
Figure 4-2.
NOTE. Processors can be installed in any processor socket. All four processor
sockets must have either a processor module or a terminator board installed
for proper bus termination.
1
2
3
4
Figure 4-2. Processor locations