Compaq ProLiant 5500 - Page 65

4-7
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: E-CH04.DOC Last Saved On: 2/12/99 12:18 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
2. Remove one of the terminator boards by turning the retaining knob
counterclockwise, releasing the side tabs and pulling up as shown in
Figure 4-3.
1
2
2
3
Figure 4-3. Removing the terminator board
3. See Figure 4-4 for processor installation procedure.
1
2
2
3
Figure 4-4. Installing the processor