4-8
Installing Hardware Components
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: E-CH04.DOC Last Saved On: 2/12/99 12:18 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
4. Install the processor power module (PPM) in the slot next to the
processor as shown in Figure 4-5.
1
2
3
4
Figure 4-5. Processor power module locations
1
2
2
Figure 4-6. Installing the processor power module
To Next Page
Loading...
