4-11
Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Writer: Michele Wray Project: Compaq ProLiant 5500 and 5500R Servers Setup and Installation Guide Comments: 328470-002
File Name: E-CH04.DOC Last Saved On: 2/12/99 12:18 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Memory Banks
In the Compaq ProLiant 5500 and 5500R server, the memory board is grouped
into 4 banks where 1 bank is 2 DIMMs adjacent to 2 other DIMMs as shown
below for bank 1. When memory is added, you must add 1 bank at a time.
Memory banks are also identified on a label on the inside of the access panel.
DIMM 3
DIMM 4
DIMM 7
DIMM 8
DIMM 11
DIMM 12
DIMM 15
DIMM 16
DIMM 1
DIMM 2
DIMM 5
DIMM 6
DIMM 9
DIMM 10
DIMM 13
DIMM 14
Bank 1
Bank 2
Bank 3
Bank 4
Figure 4-10. Memory banks on the memory board
Support for 50-ns DIMMs
Your server supports 50-ns and 60-ns Dual Inline Memory Modules. You can
mix 50-ns and 60-ns DIMMs in the server; however, each DIMM of a given
bank must be of the same size, type, and speed. If you mix 50-ns and 60-ns
DIMMs, the memory speed is adjusted to the slower DIMM speed.
To Next Page
Loading...
