LPOD Outdoor Amplifier / Block Up Converter (BUC) Revision 9
Table of Contents MN-LPOD
vii
A.5 Ethernet-based Monitor and Control .................................................................................. A–7
A.6 1:1 Redundancy System Cabling and Installation ................................................................. A–8
A.7 Redundancy System Assembly Kits .................................................................................... A–10
A.7.1 Common Kits ........................................................................................................................... A–11
A.7.2 LPOD PS 1 1:1 Redundancy Kits .............................................................................................. A–25
A.7.3 LPOD PS 1.5 1:1 Redundancy Kits ........................................................................................... A–41
A.7.4 LPOD PS 2 1:1 Redundancy Kits .............................................................................................. A–49
APPENDIX B. CABLE DRAWINGS ..................................................................................... B-1
B.1 Overview ............................................................................................................................ B-1
B.2 Control and Data Cables ...................................................................................................... B-1
B.2.1 Serial Interface Cable ................................................................................................................. B-2
B.2.2 Ethernet Interface Cable............................................................................................................ B-3
B.2.3 19-Pin COM Cable (100’) ........................................................................................................... B-4
B.2.4 19-Pin COM Cable (250’) ........................................................................................................... B-5
B.2.5 Redundant Loop Cable – Rx / Tx ................................................................................................ B-6
B.2.6 Redundant Loop Cable – Tx Only ............................................................................................... B-7
B.3 RF Cables ............................................................................................................................ B-8
B.3.1 RF Cable (Type ‘N’) ..................................................................................................................... B-9
APPENDIX C. MAINTENANCE .......................................................................................... C–1
C.1 Introduction ....................................................................................................................... C–1
C.2 Cleaning the LPOD PS-1 Heat Sinks ...................................................................................... C–2
C.3 Cleaning the LPOD PS-1.5 Heat Sinks ................................................................................... C–5
C.4 Cleaning the LPOD PS-2 Heat Sinks ...................................................................................... C–9
TABLES
Table 2-1. ‘J2 | RF OUT’ Interface Type .................................................................................................... 2–3
Table 2-2. LPOD PS 1/PS 1.5 ‘J3 | POWER IN’ Pin Assignments ................................................................ 2–4
Table 2-3. LPOD PS 2 ‘J3 | POWER IN’ Pin Assignments ........................................................................... 2–4
Table 2-4. LPOD PS 1
‘J3 | POWER IN’ Pin Assignments ........................................................................... 2–5
Table 2-5. LPOD PS 1.5 ‘J3 | POWER IN’ Pin Assignments ........................................................................ 2–5
Table 2-6. LPOD PS 2 ‘J3 | POWER IN’ Pin Assignments ........................................................................... 2–6
Table 2-7. LPOD PS 2 ‘J3 | POWER IN’ 48VDC Pin Assignments ............................................................... 2–6
Table 2-8. LPOD ‘J6 | COM1’ Pin Assignments ......................................................................................... 2–7
Table A-1. Parts List for KT-0000116 LPOD Rx Splitter / Cable Kit .......................................................... A–11
Table A-2. Parts List for KT-0000098 LPOD C-Band Rx Switch Kit ........................................................... A–14
To Next Page
Loading...
