LPOD Outdoor Amplifier / Block Up Converter Revision 9
Ethernet-based Remote Product Management MN-LPOD
4–25
• An operating parameter is changed, e.g., when a command that changes an operational
value is executed successfully;
• A fault condition is triggered;
• A redundant switchover occurs.
4.5.4.4.2 Status | Status
Use this read-only page to review all pertinent information about the LPOD.
Unlike the remaining pages available through this interface that refresh/update
only when manually selected, the ‘Status | Status’ page updates automatically
once every 10 seconds. Even with this automatic refresh function, you may click
[Refresh] to update the operational status parameters found on this page.
Figure 4-11. Status | Status page
To Next Page
Loading...
