EasyManua.ls Logo

Comtech EF Data LPOD - Page 91

Comtech EF Data LPOD
224 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LPOD Outdoor Amplifier / Block Up Converter Revision 9
Ethernet-based Remote Product Management MN-LPOD
4–19
AmplifierUse the drop-down list to select the amplifier as either On or Off.
Attenuation (dB)Enter a valid attenuation level (00.00 to 20.00 dB) in 0.25 dB steps.
Attenuation OffsetEnter a valid value, in dB, for the attenuation offset.
Fault Recovery Use the drop-down list to select Fault Recovery as either Automatic or
Manual.
MuteUse the drop-down list to select the Mute function as either Enabled or Disabled.
AUX Mute Use the drop-down list to select the Auxiliary Mute Mode as either Enabled or
Disabled.
Offline Mute Use the drop-down list to select the Offline Mute function as Enabled,
Disabled, MuteRx, MuteTx, MuteRx+LNB, or MuteTx+LNB.
Click [Change Configuration] to save any changes. Otherwise, click [Reset] to revert to the
previously assigned Amplifier settings.
Reference
Ref Freq Adjust Enter a numeric value from 0 to 255 to adjust the reference oscillator
tuning voltage. The default value is set to 87.
Ext Ref Mute Use the drop-down list to select the Eexternal Reference Not Present Mute
Mode as either Enabled or Disabled.
Click [Change Configuration] to save any changes. Otherwise, click [Reset] to revert to the
previously assigned Reference settings.
Low Power Forward Threshold (dBm)
Use this field to set the threshold value, in dBm, for the low forward power alarm/fault. When
the forward power monitor is set to Alarm or Fault instead of the factory default of Mask, and
the forward power drops below the specified value, the alarm/fault is indicated.
Setting this parameter to the default value of 00.00 effectively disables the threshold.
Click [Change] to save any changes. Otherwise, click [Reset] to revert to the previously assigned
Low Power Forward Threshold setting.
FSK Address
Use this field to set the FSK (Frequency Shift Keying) Address from 01 to 15. Click [Change] to
save any changes. Otherwise, click [Reset] to revert to the previously assigned FSK Address.

Table of Contents

Other manuals for Comtech EF Data LPOD

Related product manuals