LPOD Outdoor Amplifier / Block Up Converter Revision 9
Ethernet-based Remote Product Management MN-LPOD
4–22
• Enter a time using HH:MM:SS format (where HH = hour [00 to 23], MM = minutes [00 to 59],
and SS = seconds [00 to 59]).
Click [Change Date/Time] once you enter the desired date and time.
Circuit ID
Enter a Circuit ID (unit identification label) string of up to 48 characters.
Click [Change CID] once you compose the desired unit identification label.
Current Active Firmware Image # (read-only)
The selected Current Active Firmware Image is identified here. In this example, Image 2 is the
Current Active Firmware Image.
Next Reboot Image
Use the drop-down list to select the Next Reboot Image as Image 1 or 2. Press [Submit] when
done.
Perform Soft Reboot
Click [Reboot Now] to reboot the LPOD using the Current Active Firmware Image.
Firmware Information (read-only)
This read-only scrollable window provides information about the currently loaded Bootrom. For
the complete Bulk1 and Bulk2 information, scroll through all the constituent firmware blocks
that make up the bulk.
Part Number (read-only)
This read-only scrollable window provides identifying part number information for the unit in
use.
To Next Page
Loading...
