Conquest Imaging GE Voluson E10 - Page 38

GE Voluson E10 Training Manual
© 2017 Conquest Imaging
33
connection.
Retry Count Seq. - Retry count for sequential mode (only valid if Send
sequ. is checked). If the end number of Retry Count Seq. is reached
and sending was not successful then the “problem” data set is
marked as “failed” in the spooler and the system continues sending
the next image data
Retry Interval - Retry interval minutes.
Timeout (s) - Define a timeout interval.
Default - Default values of Retry Count, Retry Count Seq., Retry
Interval, Timeout (s) are set.
Test Connection - If a destination from the Destination List is selected
and the Test Connection button is pressed, the connection to the
selected destination is tested. If no destination is selected the button
is disabled.
Ping: Ping the selected destination and check the response.
The result can be OK or Failed
Verify: Send DICOM commands and check the response. The
result can be OK or Failed.
If a serial report destination is selected, the Test Connection button
changes to Send Test Report and the Ping and Verify fields disappear.
A test report is sent to the serial port instead of testing the network
connection.
Sound Notification - Acoustic signal for a successful or unsuccessful
transfer (sending Images, Structured Report Transfer and Report).
Destination List - Contains all available destinations and displays:
 Services
 Alias
 AE Title
 IP Address
 Port
 Color / Size
In the checkboxes next to the destination, mark the currently