Conquest Imaging GE Voluson E10 - Appendix 1 Network Configuration Worksheets; Checklist for Configuring Ultrasound System Network Parameters

GE Voluson E10 Training Manual
© 2017 Conquest Imaging
Appendix 1 Network Configuration
Worksheets
You can print out these pages to gather information when preparing
for network configuration. Most of the necessary information can be
obtained from the system administrator or IT department of the
facility.
Checklist for Configuring Ultrasound System Network
Parameters
Parameter
Description
Alias
A unique identifier for the DIMAQ-IP host AE Title.
The alias is only used only by the ultrasound system,
and not by DICOM, the Alias makes it easier to
switch between hosts if the machine is to be used in
multiple subnets or networks.
AE Title
The AE Title of the DIMAQ-IP host.
Host Name
The full computer name of the DIMAQ-IP host.
Workgroup
The workgroup name of the DIMAQ-IP. An entry is
always required for this parameter.
DHCP
Is Dynamic Host Configuration Protocol used?
The parameter value is always either Yes or No.
Subnet Mask
The IP address of the subnet mask. The system
needs this to see other nodes on the network. If no
subnet mask is available, use 255.255.255.0
The DICOM server may
need to be configured to
recognize the ultrasound
system. The storage
device vendor needs to
know the ultrasound
system AET and port
number (104).
You can obtain this
information from the
facility network
administrator or IT
department. The service
person for the DICOM
devices may also have the
IP addresses for the
subnet mask and
gateway.