Conquest Imaging GE Voluson E10 - Adding a Service; Services

GE Voluson E10 Training Manual
© 2017 Conquest Imaging
34
activated server. If more than one Service is added, then a selection
of one Service can be done with the checkbox.
To check the same Services is not possible for:
 Print
 MPPS
 STR. Report
 Query Retrieve
 Worklist
When more than one STORE, STORE3D or STORAGE COMMIT service
is activated, images are sent to all selected STORE or STORE3D
destinations and committed with the corresponding STORAGE
COMMIT destinations.
Add - Pressing the Add button opens the Device Setup dialog, where
it is possible to add DICOM destinations. For more information see
'Adding a Service'.
Edit - Selecting a destination from the Destination List and pressing
the Edit button opens the Device Setup dialog, with the information
on the selected destination.
Delete - Selecting a destination from the Destination List and
pressing Delete removes the selected destination. The Delete button
is disabled if no destination is selected.
Save&Exit - When the Save&Exit button is pressed, the DICOM
Configuration dialog is closed and all changes are saved.
Exit - When the Exit button is pressed, the DICOM Configuration
dialog is closed and all changes are discarded.
Adding a Service
Select a Service and enter the destination settings (Alias, AE Title, IP
Address and Port).
Services
The following services are available:
The Edit button is disabled
if no destination is
selected.
The Delete button is
disabled if no destination
is selected.
Note: In Edit mode it is
not possible to change the
selected Service.