Product Manual — Doc. 9349B Crestron Zūm® Wired Solutions • 145
Remove a Missing Device from a Zūm Wired Room
To remove a missing device from a Zūm Wired room:
1. Identify the primary load controller.
The LINKLED on the primary load controller consistently flashes for 0.5 seconds on and
0.5 seconds off.
2. Perform a factory reset on the load controller.
Refer to Perform a Factory Reset on a Load Controller on page 143.Refer to Perform a
Factory Reset on a Load Controller.
3. Reassign the load controller as the primary controller.
Refer to Assign a Load Controller as the Primary Controller on page 144.
NOTE: Performing a factory reset on a primary load controller erases all previous room logic
to the default settings.
Refer to Zūm App Configuration on page 152for configuring the device.
To Next Page
Loading...
