Spider DSA User’s Manual
113
Each time the user presses the Run button and the test finishes, a numbered Run
is generated. By default, a Run folder is created on the disk. As shown in the
picture above, for a given test, Random1, a test file, Random1.stk, is created. Each
Run in the Run Folder tab corresponds to a physical folder on the disk.
Data Files are time streams and block data saved or recorded to disk. All of the
data files under a specific Run will be saved into that Run folder. When block
signals are saved by clicking the Save Sigs button, a data file will be created and
displayed here.
Figure 70: Data Files Tab
Right-click the data file to open the file location, open in Post Analyzer software,
enter Review Mode, enter Compare Mode, export, delete, or export to single file.
To Next Page
Loading...