Crystal Instruments Spider - Apply Alarm Limits

Spider DSA User’s Manual
326
Testing
Schedule
Testing Log
Summary
Report
Compare the signals and
their limits in runtime
Alarm Event
Setup
Beep, send message to Host
PC etc.
Compare the signals and
their limits in runtime
Setup
Events and report
Figure 195. An Illustration of the Automatic Testing Process
Apply Alarm Limits
Limiting and alarm function only works with the master module in a high-
channel count system. This limitation doesn’t affect other modules measuring
signals. In an FFT test, right-click the signal name and then click Apply Alarm
Limits to setup limits parameters. Users can also decide here if the limit lines will
be displayed with the signals.
Figure 196. Apply Alarm Limits
On the alarm limits list, click Add Limit to add a new limit to the list.