Spider DSA User’s Manual
346
By adding new tests repeatedly, users can create up to 64 tests with 64 Spider
devices under any one project and run all tests under any one project
simultaneously. Click the test name in the Recent Tests tab to make the test
active. There is only one active test at a time.
Control Panel
The Control Panel is used to control the test and to display status information in
real-time. The connection status of the hardware is shown on top with a button to
Connect/Disconnect (if no hardware is detected, this button will not be
displayed). The control buttons — Run, Hold, Stop, Rec., Save — duplicate the
items in the Control menu and on the Control toolbar. Config opens the Test
Configuration window.
Information on the state of active test is displayed below the control buttons. This
status information includes the output level (as a percent of the test profile) and
peak voltage, the control input peak and RMS level, the target peak and RMS level,
and the elapsed and remaining time.
Followings are the definitions of all function buttons and status information.
To Next Page
Loading...