Spider DSA User’s Manual
372
Figure 233. Surface Editor in ODS Editor
The surface is defined by connecting three points, V1, V2, and V3. And each
surface is of the triangle shape. The visible column defaults to be checked. It can
be unchecked, in case a line needs to be disabled.
Color of each surface can be selected using the pull-down button at the Color
column.
To add a new surface, scroll down to the bottom, and click the empty line. To
delete a surface, highlight the line of that surface, and click the Delete button on
the right top corner.
Click Accept button will save the changes made and make the other tabs available.
Previous/Next buttons
These two buttons provide the operation of cancel and redo.
Undo
This will cancel the previous editing action. The button is available, only after a
change is made to the geometry model. And it allows to go back only 1 step.
Redo
This will redo the canceled action. It is active after the “Undo” button is clicked.
Component library
EDM DSA ODS Editor has a library of built in component library to help build
geometry model more efficiently.
To Next Page
Loading...