Spider DSA User’s Manual
295
Figure 201: Measured signals setup – RPM Streams
Like time streams, the Measure attribute for each signal can be checked /
unchecked to enable / disable measuring the RPM time stream signal.
The signal can also be recorded as a time stream to the internal flash when the
Record List attribute is selected for the signals that are required for recording.
Order Spectra
Order Spectra provide the spectra of the channels in terms of Orders. The
following picture shows the Measured Signals setup for the Order Spectra from a
single Spider-80X module. When multiple modules are used, the number of
Order Spectra is increased by 8 per module (up to a maximum of 128 channels).
To Next Page
Loading...