Spider DSA User’s Manual
251
Measured Signal Setup
Figure 162: Signal Setup Window
The Signal Setup page is under Setup->Measured Signals. This tab lists all
signals with a Measure option. In addition, time stream signals have a Record
List option and block signals have a Save List option. Measure enables the
channel for display, Record List enables the channel for recording, and Save
List enables the channel for block saving. Only time-stream signals can be
recorded and only block signals can be saved.
The signals are divided by type in the tabs on top. The Time Stream tab lists the
native time stream signals. The other tabs list signals that are derived or
computed from these native signals. These derived signals are organized in blocks
rather than continuous streams. Deselecting Measure for these derived signals
disables their computation and saves processor resources. When recording is
activated, by the menu command or the Rec. button on the control panel, all
signals with the Record List option enabled will be recorded to file. When the
Save Sigs Button is pressed, all signals with the Save List option enabled will be
saved to disk.
The trace color used to display the signals can also be specified here.
To Next Page
Loading...