Spider DSA User’s Manual
305
Make sure the device is connected, if the device is not connected, then the
Connect button would be enabled. Click on Connect to connect the Spider-80X
module to the EDM.
Once the module is connected, click on Run to start running the test.
Click on Hold to suspend processing at any point of time, this will freeze all the
calculations and the existing displayed signals will “freeze”. Click on Continue to
continue the test into the running state again.
The Record button initiates recording of all time stream signals selected for
record in Measured Signals. Pressing the Save button triggers saves all the
current block signals to the Spider Internal flash or the PC. For further
information, navigate to Save and Record Settings in this manual.
Stop completely stops the test and the recorded and saved signals from the
Spider hardware module can be downloaded to the PC.
Display signals
As seen from the previous section, the left-hand bottom pane of the EDM default
screen consists of the Live Signals tab which contains all the required signals
that may need to be viewed.
All the signals that have the Measure attribute enabled are displayed here.
The following Figure shows the typical Live Signals tab for an Order tracking test
with all categories of enabled signals.
To Next Page
Loading...