Spider DSA User’s Manual
81
negative or positive direction. Any device that can read such a voltage signal can
then be controlled by the data acquisition/controller system.
The programming of digital input and output is on the Digital IO Setup tab of
Testing Configuration dialog box.
To activate a test using a digital input signal, check one of the listed digital input
pins and click on the Set Run Test Pin button.
The digital output default state is set to be used by Send Digital Output
Signals event. Refer to Event Action Rules chapter for more details about this
event.
The state of the digital inputs and outputs can be displayed with the Digital I/O
View in the View->Digital I/O tab in EDM.
Figure 33. Digital I/O Window
What is Included in the Box
Spider-20 Dynamic Measurement System
Included Accessories:
To Next Page
Loading...