Crystal Instruments Spider - Updating Firmware; Creating a New Test

Spider DSA User’s Manual
51
When all the front-end modules have been connected, bring up the hardware
configuration window by clicking on Spider Config, or Tools->Spider
Configuration.
Detected and previously used modules will be listed on the left side by IP address
and serial number. The top right section shows the modules in the currently
selected system, and the section below lists settings for the selected module. To
create a new system, click the Create a New Spider System button on the
bottom left, enter a name for the system, and select the module or modules to
include.
Figure 7: Spider System Configuration
Updating Firmware
All front-end devices should be kept up to date with the latest firmware to ensure
the best operation. The desktop software will automatically detect and update the
firmware on connected modules. To manually update or change the firmware on
a device, contact a Crystal Instruments tech support engineer at +1(408)986-
8880.
Creating a New Test
Once the front-end system has been configured and connected, a test can be set
up by clicking on New Test.