Spider DSA User’s Manual
252
Test Configuration
The Test Configuration window is used to set test-specific software options and
parameters. It is divided into a number of sections accessed by the list on the left.
Many of these sections are specific to a particular test mode, and are described in
the subsequent chapters regarding these modes. Other sections are for common
functions shared by all test modes, and are described in their own sections of this
manual. This window will be referenced many times throughout this text.
To access these settings, go to Setup, select the Test Configuration item under
the Setup menu, or click the Config button on the control panel.
Figure 163: Access to Test Configuration
Running a Test
If microphones are used, a good check is to clap your hands near each
microphone and observe that a signal has been heard. The Input Channel Status
also provides an overview of the current input levels. It can be activated from
View->Channel Status.
To Next Page
Loading...