Crystal Instruments Spider - Measured Signals Setup

Spider DSA User’s Manual
291
For the 7.4, hardware units, the output channels can only be used for generating
outputs and the output channel settings can be viewed or set using the control
panel output tab or the navigating to the Output Channels setup from “Setup”
menu item and clicking on “Output Channels”.
A more detailed description of the specific usage of the output channels to
generate different types of signals as output is described in the Output Channels
section of this manual.
Measured Signals Setup
Signals that need to be measured including the option to include selected signals
in the Record or Save list is done using the Measured Signal setup. Additionally,
Order spectrum, configuring Order tracks and RMS Band spectra can also be
done using the measured signals setup.
To open the measured signals setup page, click on the menu item, “Setup” and
click on “Measured Signals”.
The following figure shows the Measured Signals setup page for a typical Order
tracking test with one Spider module.
Figure 198: Measured signals setup
The signals are categorized into multiple tabs each signifying a particular class of
signals.