Spider DSA User’s Manual
88
Measured Signals opens the measured signal dialog box. The measured signals
are those signals that can be displayed or stored.
Test Sequence lets the user set up a number of tests so the software can run
them one by one.
Figure 38. Example of Test Sequence Setup
Black Box Setup allows the user to upload, refresh, or remove the tests from the
front-end box. A test uploaded to the Spider devices can be run in the black box
mode and can be accessed by DIO, front panel buttons or an iPad.
Alarm Limits allows the user to bind customized limits on the test.
Control Menu
Commands for controlling the test such as: Run, Hold, and Stop, are found under
the Control Menu. These commands are duplicated on the Control Panel on the
right side of the screen. There are also commands for recording time streams and
saving block signals, which can be used even while a test is in Stop mode.
To Next Page
Loading...