Spider DSA User’s Manual
53
Figure 11: Test Control Panel
Saving Signals and Recording Time Streams
Different options are available to save measurement data. EDM uses the terms
Save for block data and Record for time stream data. Blocks of data, which
include time-domain and frequency domain blocks, can be manually saved by
clicking the Save button or automatically captured based on a trigger setting.
Time stream data can be recorded manually by pressing the Rec. button or by
using a run schedule. Data can be stored on the internal flash memory of the
front-end device or on a hard drive connected to the PC.
To select which signals to save or record, click on Setup->Measured Signals.
Under this tab, signals are organized according to their type; each signal can save
or record.
To Next Page
Loading...