Spider DSA User’s Manual
281
Figure 174. Run Folders
Data Files are time streams and block data saved or recorded to disk. All of the
data files under a specific Run will be saved into that Run folder. When block
signals are saved by clicking the Save Sigs button, a data file will be created and
displayed here.
Control Panel
The Control Panel is used to control the test and display status information in
real-time. The connection status of the hardware is shown on top, with a button to
Connect/Disconnect (if no hardware is detected, this button will not be
displayed). The control buttons — Run, Hold, Stop, Save— duplicate the items
in the Control menu and on the Control toolbar. Config opens the Test
Configuration window. Rec./Stop starts/stops the recording after test runs.
To Next Page
Loading...