Spider DSA User’s Manual
304
Figure 212: Measured signals setup – All Signals
The user can enable or disable each signal by checking or un-checking the
Measure attribute. The user can also modify the Save / Record attribute for each
signal.
The additional attributes with signals, such as Order Tracks and Band RMS
Spectra cannot be edited or viewed from this tab.
Running a test
The following key aspects must be verified before running a test:
1. The analysis settings are configured correctly. The settings include the
Tachometer settings, Order Analysis settings and FFT analysis settings.
2. The Input channels have been configured appropriately
3. The Measured Signals have been augmented with all desired signals added to
the Measured list and Save/Record list.
4. The tachometer is connected correctly and the physical connections with all
the input channels are appropriately set.
Once the above settings are verified, the test can be run.
To Next Page
Loading...