Spider DSA User’s Manual
282
Below the control buttons, information on the state of the test is displayed. For a
typical Order tracking test, the total elapsed time and the RPM of the enabled
tachometer channels is displayed.
A few key parameters that are important to the Order Analysis are also displayed.
These settings can be changed from the Test Configuration Setup which will be
dealt with later in this section.
The function buttons are used to undertake specific functionalities.
Trigger Switch: arm/disarm the trigger. Click Setup button to configure the
trigger.
Output Switch: Output channels can be used as output when 7.4 hardware
units are used or when a tachometer is disabled in a 7.5 hardware unit. This
button turns an available output channel(s) On or Off.
To Next Page
Loading...