Spider DSA User’s Manual
373
Add Line
To add a beam type of structure to the geometry model, click the Add Line icon,
following window popes up.
Figure 234. Add Line Window
The entries to the Starting Point, X, Y, and Z define one end of the line. While the
End Point entries of X, Y and Z define the other end. The Cell count is the number
of sections will be added to this line. The number of points on the line will be the
cell count plus 1. Click OK will result in a model of a beam, shown as following.
Figure 235. Sample Beam Model in ODS Editor
To Next Page
Loading...