Spider DSA User’s Manual
134
Spectrum Type defines the units for spectrum signals as power spectral density
(EU
2
/Hz), energy spectral density (EU
2
s/Hz), squared units (EU
rms
2
), peak units
(EU
peak
), or RMS (EU
rms
). Again, this only applies to frequency-based signals.
Signal Color defines the color scheme used for the signal plot.
Report this Window generates a report from the window in MS Word format.
RMS Display Setup defines how RMS values are displayed on the plots. RMS
values can be displayed for the overall signal on each plot or only for a specified
frequency band.
Figure 93: RMS Display Setup
Customize Notation Setting allows the user to edit numerical value notation
and floating-point formatting.
Plot Properties opens the Plot Properties section of the EDM Global Settings.
NOTE: The background color of the plot can be edited from the Plot
Properties->Plot tab as shown below. The background color is only applied to
plots displayed on the screen; it will not be applied to plots in generated reports;
these will have a white background. Please note that if plot lines are also white
then the plots generated in reports will appear blank (white on white).
To Next Page
Loading...