Spider DSA User’s Manual
196
Reset Average clears the average and resets the current average number back to
zero. This nullifies the effects of an unwanted event.
Turn Output On/Off enables / disables the output channel of the Spider
device. The output settings can be configured under output tab of the control
panel.
Figure 139. Output Type Selection
View Window opens the window configured for the test.
Setup Trigger gives the option of setting up a trigger-based action with the help
of event action rules. Only the input channels on the master module can be set as
the trigger source.
Trigger Switch turns the trigger On/Off.
Output Switch turns the output On/Off.
Limit Check Switch enables/disables the limit check.
To Next Page
Loading...