Spider DSA User’s Manual
302
RMS Calculate refers to the band of frequencies over which the RMS needs to
be measured. The user can select Overall which spans all the frequencies
governed by the frequency range of the test.
Start and Stop Frequencies denote the start and stop frequencies of the band.
Click on Add to add the signals, the added signals can be viewed (and deleted)
from the left side section of the window.
Figure 210: Adding Band RMS Spectra
Multiple bands for the same channel can be added as shown in the Figure above.
When all the required Band RMS signals have been added, click on “OK” to
navigate to the Measured Signal setup page with all the added Band RMS signals
as shown in the Figure below.
To Next Page
Loading...