Spider DSA User’s Manual
348
Hold button is to pause the test without stopping it. Paused test can be resumed
by clicking the same button again. When the test is on hold, the Hold button
becomes the Cont. button.
Stop button is to stop running the test.
Rec. button is to start timestream recording on channels according to the record
list in the Measured Signals Setup. When the recording is in progress, press the
same button to stop recording. Recorded data files are stored on the Spider’s
internal flash memory.
Save button is to save signals according to the save list in the Measured Signals
Setup. Saved data files are stored on the Spider’s internal flash memory.
Configure button is to open the test configuration window where you can
configure analysis parameters, run schedule, event action rules, and
save/recording setup.
Total Elapsed shows the total elapsed time of current active test according to
the run schedule.
Latitude/Longitude is the GPS position of the Spider device on which the
active test is running. It is acquired from a GPS antenna attached to the cellular
gateway.
Number of Alarms is the number of times when the alarm is triggered.
New Data Files is the number of newly generated data files during the duration
of total time elapsed.
Download Data button is to download all data file from the Spider device with
active test running. You cannot choose which data files to be downloaded. If you
don’t want to download all data files, please go to Tools tab, and then click
Download from Spider Internal Storage button to choose specific data files to
download. During the download process, Test Name, Spider S/N, Number of File
to Download, Total Size, and Status.
Click the Hide button to make the download running in the background; click the
Cancel Download button will immediately stop the download.
To Next Page
Loading...