Spider DSA User’s Manual
409
2. Click Configuration on the top left side of the window and select PTP. This page allows
the user to configure and inspect the current PTP clock settings. PTP Clock
Configuration has to be enabled.
3. Click on the button “Add New PTP Clock” and configure the clock. The settings are
shown in the picture below. Click on the “Save” button after the clock settings are
set.
Clock Instance: 0
Device Type: E2eTransp
2 Step Flag: True
One Way: False
Protocol: IPv4Multi
VLAN Tag Enable: unselected
VID: 0
PCP: 0
To Next Page
Loading...