Each time the ignition is switched on, the dis-
tance warning will reappear as active.
CUPRA recommends having the safety dis-
tance warning activated except in the excep-
tions described in section page214, Tempo-
rarily deactivating Front Assist.
Activating or deactivating the swerve and
turn and junction assist
The swerve and turn assistance systems can
be activated or deactivated in the infotain-
ment system using the function button >
Driver assist > Smart Assistants > Front Assist
›››page40.
Whenever the ignition is switched on, the
swerve and turn and junction assist will reap-
pear as active.
CUPRA recommends having the swerve and
turn assistance systems activated except in
the exceptions described in section page214,
Temporarily deactivating Front Assist .
Temporarily deactivating Front Assist
In the following situations Front Assist should
be deactivated due to the system's limitations:
●
When the vehicle is to be towed.
●
If the vehicle is on a test bed.
●
If the radar sensor or the front camera is
faulty.
●
If the radar sensor or the front camera has
suered a violent blow.
●
If it intervenes several times unnecessarily.
●
If the radar sensor or the front camera is
temporarily covered by an accessory.
●
When the vehicle is going to be loaded onto
transportation.
●
If the windscreen is damaged in an area that
covers the vision of the front camera.
Lane Assist system
Introduction
The Lane Assist System helps the driver stay
in his/her lane within the physical limits of the
system. This function is not suitable and is not
designed to keep the vehicle automatically in
the lane.
Using the camera located in the windscreen,
the Lane Assist system detects the lane boun-
daries dividing the lanes in which the vehi-
cle is travelling. If the vehicle gets too close
to the detected lane limits, the system alerts
the driver through a corrective motion of the
steering wheel. The driver can cancel the
steering corrective action at any time.
No warning will be given when the turn signals
are activated, given that the Lane Assist system
understands that a lane change is required.
System limits
Use the Lane Assist system only on large, well-
maintained motorways and highways.
The system is not available under the following
conditions:
●
The driving speed allowed is below approx.
60 km/h (35 mph).
●
The system has not detected any lane lines.
●
On tight bends.
●
Temporarily in very sporty driving situations.
●
If the driver rmly recties a system interven-
tion.
●
If a lane marking is crossed despite system
intervention.
●
If the driver does not react to a request to
intervene.
WARNING
The intelligent technology in the Lane Assist
system cannot change the limits imposed by
the laws of physics and by the very nature of
the system. Careless or uncontrolled use of
the Lane Assist system may cause accidents
and injury. The system is not a replacement
for driver awareness or manoeuvres when
driving.
●
Always adapt your speed and the distance
to the vehicles ahead in line with visibility,
weather conditions, the condition of the
road and the traic situation.
●
Always keep your hands on the steering
wheel so it can be turned at any time. The
responsibility of staying in the lane is always
the driver's.